Gerber Silver Knight Mother of Pearl

BRAND:   Gerber

PATTERN:   Silver Knight

LENGTH (Closed):   3-1/4”

BOLSTERS:   Stainless Steel

HANDLES:   Mother of Pearl

BLADES:   Lockback Drop Point

LINERS:   Stainless Steel

FRONT TANG STAMP:   GERBER / PORTLAND, OREGON / 97223 U.S.A.  

REAR TANG STAMP:   SILVER KNIGHT / BY SAKAI JAPAN

CONDITION:   Excellent

DAMAGE:   Some scratches from use to the blade. Probably some minor scratches to the handles and bolsters, though they are not readily visible. One very minor spot near the lock on the mark side that may be an imperfection or a place where an imperfection has chipped. It is approximately the size of a pin prick. Aside from that this is one of the nicest looking mother-of-pearl handles I've seen on one of these older Silver Knights.

BLADE WEAR:   Approx. 10%

SNAP:   Very Good

MADE IN:   Japan

ADDITIONAL INFO:     This is the middle of the three sizes of the Silver Knight series. They were made in Sakai Japan for Gerber. The series was discontinued in 1994. The blade is about 90% full on this knife. It has been used and sharpened but bears very little evidence that it has been carried. It may have been carried in a pocket sleeve or sheath. These knives do fit quite nicely in the pockets of pair of slacks. When I had to wear slacks and tie to work daily I often carried a Silver Knight of this size because they were very thin and lightweight and did not make a large bulge in my pocket.    The pattern is thin and lightweight that it's hardly noticeable in the trouser pockets of a suit or pair of slacks.

*By Purchasing, The Buyer Confirms It Is Legal For Them Purchase And Own This Knife.

I Accept Money Orders, Personal Checks and PayPal.

Shipped by Priority Mail flat rate box or flat rate envelope in the US.

Item # 49273