My first pearl work

agteacher2 · Post by **agteacher2** » Mon Apr 24, 2006 12:32 am

Here is my first attempt at Mother of Pearl handle installation. I took a page out of the German makers book and installed them without pins showing. I think it gives it a really nice clean look. Hope you enjoy it.
In case you didn't recognize it its Case XX Stainless steel peanut.

Jeff

Hukk · Post by **Hukk** » Mon Apr 24, 2006 12:53 am

Thanks for the post. Your talent is showing. First pearl, I think I would be holding my breath at some points while working with it. Great Job!

Do you have plans for Mastodon Bark Ivory and Mammoth tooth in the future? I have a couple Bulldog Anglo-Saxons that I want to have done in the future? I will have to run that by my wife (da Boss) on that one though. Once again, GREAT JOB, thanks for sharing. I know where to go when I get the blessing for my projects.

Hukk
[email protected]
Darrell Hukkanen

4ever3 · Post by **4ever3** » Mon Apr 24, 2006 11:34 am

Very nice Jeff

JOE62 · Post by **JOE62** » Mon Apr 24, 2006 12:48 pm

It just keeps getting better and better.

GREAT WORK!!

Hukk · Post by **Hukk** » Tue May 16, 2006 2:20 am

Folks this is a very fine knife. I had the pleasure of purchasing this knife and it is even better in hand. Jeff did a great job and it is a pleasure to own it.

I sent a Bulldog Anglo-Saxon down to Jeff with a couple of thick mammoth tooth scales for a knife project, something I always wanted to do.

I haven't told Jeff yet

but I had some gold lip pearl come in today for a future project and it looks fantastic.

Gr8Scout · Post by **Gr8Scout** » Wed May 17, 2006 8:45 am

Beautiful knife!
Phil