Spyderco MagnaMax

[orvet]

I went to the Spyderco table at the OKCA show last weekend. Spyderco has always been a big supporter of OKCA. They saved a few MagnaMax blades for the show. I was fortunate enough to get a couple of them. I think I will make a handle for at least one of them. I'm anxious to see how MagnaMax steel performs. I kind of wish they were only half serrated instead of fully. It might make them a little bit more difficult to compare to other steels they have fine edge blades. They are spooky sharp out of the box!