Wanted Swan Works Cutlery Blade

Looking for a particular knife or related item? Post it here.
Post Reply
Jerlin
Posts: 56
Joined: Fri May 22, 2020 3:22 pm
Location: Euless, TX

Wanted Swan Works Cutlery Blade

Post by Jerlin » Tue Jul 07, 2020 1:47 pm

I have a Swan Works Cutlery knife made in Solingen Germany. It has two blades and I believe bone handles. One blade is 2 1/4" and the other is 1 1/2". The smaller blade has broken off about 1/8" from the tang. I am looking for a replacement blade, which I'm sure is like looking for a needle in a haystack. Attached are a couple of photos of the knife.
Swan Works Cutlery knife
Swan Works Cutlery knife
Close up of blades with stampings. Vertical blade is the broken one.
Close up of blades with stampings. Vertical blade is the broken one.

Suredan
Posts: 12
Joined: Sat Oct 06, 2018 12:44 am

Re: Wanted Swan Works Cutlery Blade

Post by Suredan » Tue Jul 07, 2020 3:13 pm

I’ll just bet you are going to have to consider having a pen blade welded on to save that tang stamp. Or..... delete the pen blade altogether. That would make a nice slim knife. Good luck with your quest.

Jerlin
Posts: 56
Joined: Fri May 22, 2020 3:22 pm
Location: Euless, TX

Re: Wanted Swan Works Cutlery Blade

Post by Jerlin » Tue Jul 07, 2020 3:57 pm

Suredan, I thought about the possibility of having a blade welded on the tang to save the stamping, but I don't know who does that type of work. I probably should post in the repair/restore forum. I would really like to keep the knife as original as possible. Thanks for your input.

Jerry Johnson

thefarside
Gold Tier
Gold Tier
Posts: 392
Joined: Tue Apr 19, 2011 3:55 am

Re: Wanted Swan Works Cutlery Blade

Post by thefarside » Wed Jul 08, 2020 3:56 pm

Check your PM's

Post Reply

Return to “Want Ads”