A buck 110

muskrat man · Post by **muskrat man** » Wed Mar 07, 2007 9:58 pm

I finished this for a customer out in Arizona. I have named this one the piccaso snake. He specified what exactly he wanted done, a rear and front bolster removed and a snake fileworked into the lock bar and blade with his head near the clip and a rattle at the end. He sent the Koa too, I really like this wood. I'm not sure if I like this knife or not.
Left

Right

filework

middle

tail

head

The pictures don't show things very well. In case you are wondering it's a 3 dot vintage flat bolster 110

El Lobo · Post by **El Lobo** » Wed Mar 07, 2007 10:47 pm

No matter what...

That is very nice work, and an interesting knife.

Bill

johnnierotten · Post by **johnnierotten** » Thu Mar 08, 2007 12:18 am

Great job and super nice file work!!

Hogkiller · Post by **Hogkiller** » Thu Mar 08, 2007 12:40 am

One bolster on each side,,,,,hmmmm.
Darn fine job there MM. I dont think i've seen a 110 like it, maybe that's what he's going for. The stippling on the lock bar and blade is OUTSTANDING by the way.

muskrat man · Post by **muskrat man** » Thu Mar 08, 2007 2:11 am

thank ya'll, I think that's what he's going for too. He like abstract type stuff, so this should fit the bill nicely, I'm mailing it out tommorow and starting up on a more challenging project. The handle fitting on this next knife is gonna be a real challenge.

orvet · Post by **orvet** » Thu Mar 08, 2007 6:33 am

Keep up the good work Kaleb!
Great as usual.

Dale