Who Made This Wards ?

WelderBob · Post by **WelderBob** » Tue Feb 12, 2008 9:29 pm

I have puzzled over this knife for a while...4 blade stockman...3 7/8" closed...stag handles....blade etch Master Quality Stainless No. 112...all blade stamped stainless...a well made knife, nickel silver liners with filework...pretty stag...good snap. What I find odd is the main blade and the punch are on the same end...has anyone seen another one similar ? I've been told it could have been made by Camillus, Utica, Western States or ???? I lean towards Camillus but not sure because of the stag handles. Your idea's and opinion's would be most appreciated. WB

rigwelder · Post by **rigwelder** » Tue Feb 12, 2008 11:22 pm

im not looking at any book right know, but i think winchester did at one time. thats a very nice knife you got there. even if winchester didnt, theyd be proud of your knife. ITS SLICK!!!

knfcollector · Post by **knfcollector** » Tue Feb 12, 2008 11:50 pm

Fairly certain that the punch indicates Camillus. Gorgeous knife!

edgy46 · Post by **edgy46** » Tue Feb 12, 2008 11:59 pm

That punch style has been on one of the forums. there was a lot of info Pat dates etc.I hope someone knows how to find it.

WelderBob · Post by **WelderBob** » Wed Feb 13, 2008 12:13 am

Thank's guys, I'd thought about Winchester just didn't think knife was old enough...Camillus punch..I thought so...but why on the opposite end as most 4bld...I will admit it is handy. WB