What is it?

muskrat man · Post by **muskrat man** » Mon Jul 24, 2017 6:43 pm

Let's see if anyone can guess what this part I just made is for. There are three different diameters and a a short square section machined onto this piece of nickel round stock.

just bob · Post by **just bob** » Mon Jul 24, 2017 8:52 pm

Is it for a gun?

muskrat man · Post by **muskrat man** » Mon Jul 24, 2017 9:19 pm

no sir it's most definitely for a knife

#goldpan · Post by **#goldpan** » Mon Jul 24, 2017 10:30 pm

Just pulled this one of my....... er I mean the air. Is it a torsion spring bar for a lock back?

philco · Post by **philco** » Mon Jul 24, 2017 11:10 pm

#goldpan wrote:Just pulled this one of my....... er I mean the air. Is it a torsion spring bar for a lock back?

That's my guess too Randy.

btrwtr · Post by **btrwtr** » Mon Jul 24, 2017 11:38 pm

Ring opener?

glennbad · Post by **glennbad** » Tue Jul 25, 2017 12:06 pm

Nickel stock, hmmm. So, not hard, so it's not a tool really. Is it a slot gauge of some kind?

Bill DeShivs · Post by **Bill DeShivs** » Wed Jul 26, 2017 1:02 am

Ring opener pivot.

muskrat man · Post by **muskrat man** » Wed Jul 26, 2017 1:04 am

Wayne and Bill got it

I figured Bill would since he just worked on one a while back.

Was a lesson in pivot pin manufacture thats for sure

All About Pocket Knives

What is it?

What is it?

Re: What is it?

Re: What is it?

Re: What is it?

Re: What is it?

Re: What is it?

Re: What is it?

Re: What is it?

Re: What is it?