Picked this up not long ago and to date no doubt my fav
... jigged bone handles and a lockback as well. I think the bolster at the pivot is iron and the lower bolster nickel silver. Knife measures 9 1/2 " open and 5 3/8" closed. It is in pretty good shape and only a really small pin crack on the backside of handle - lower pin near the iron bolster... blade is tight and snaps pretty well open but it may be the lockback I hear. There was some pitting on the blade that is evident in the right light but not terrible, and I would assume it had been sharpened at one time or another. It is pretty slow on the close... maybe I should lubricate the joint? It was cleaned pretty well when I bought it and haven't done anything to it yet but I will lube the joint and give it a light coating of Ren wax or oil. I haven't seen another like it so please post them up if anybody has another Miller Bros Hunter. Any comments - observations etc appreciated 
Cheers
Lee
- Miller Bros Hunter - Front
- Miller Bros Hunter - Back
- Miller Bros Hunter - Open
- Miller Bros Tang Stamp
- Miller Bros Hunter
We don't see many Miller Bros knives around here. I've only found one and it needs new bone on both sides.
