Just finished a Hawkbill

#goldpan · Post by **#goldpan** » Tue Jan 20, 2015 2:32 am

Just finished putting this one together. The parts were purchased from Muskrat Man. This is the second one that I have put together. It has the factory walnut grips. I think it turned out nice. I still need to put some tung oil on it to give a shine. The finish you see is from the sanding and buffing. Need to put an edge on it to.

I have enough parts to make four more of these!

This stuff is getting addicting! I thought that accumulating was bad! This could be worse...... ::nod:

Randy

philco · Post by **philco** » Tue Jan 20, 2015 2:57 am

Looks good Randy.

How's the snap on that one ?

FRJ · Post by **FRJ** » Tue Jan 20, 2015 3:00 am

Looks to be a very nice job.

#goldpan · Post by **#goldpan** » Tue Jan 20, 2015 3:11 am

Hey thanks guys!
Phil, she snaps like a trap! Gotta keep the fingers out of the way! I haven't put an edge on it yet, but the point is needle sharp. Ouch!

Randy

glennbad · Post by **glennbad** » Tue Jan 20, 2015 3:38 am

Nice looking work, Randy!

orvet · Post by **orvet** » Tue Jan 20, 2015 6:19 am

It looks good!

TripleF · Post by **TripleF** » Tue Jan 20, 2015 8:51 am

Knice work Randy!!!

All About Pocket Knives

Just finished a Hawkbill

Just finished a Hawkbill

Re: Just finished a Hawkbill

Re: Just finished a Hawkbill

Re: Just finished a Hawkbill

Re: Just finished a Hawkbill

Re: Just finished a Hawkbill

Re: Just finished a Hawkbill