Remington question

Salernoslim · Post by **Salernoslim** » Mon Sep 22, 2014 7:05 pm

I just picked this knife up on eBay. I generally stay away from older case and Remington knives as I have very little knowledge of them and they seem to be the two most faked. I collect this pattern and needed a Remington to go with my collection. The pattern number is R2043. I did a google search on the numbers and the only one I could find was an equal end jack. The blades and the bolsters show about the same amount of wearer and there is no pin showing through. I figure if it's not right it's a good chance to learn something. Any help is appreciated.

knife-nut · Post by **knife-nut** » Mon Sep 22, 2014 9:14 pm

I don't see anything wrong with it.

Mark.

msteele6 · Post by **msteele6** » Mon Sep 22, 2014 9:36 pm

Knife is listed in Stewart and Ritchie's book and shown as a regular bare headed jack without a shield. It is listed as being 3 1/8" closed.

As stated by knife-nut, the knife looks fine.

Salernoslim · Post by **Salernoslim** » Mon Sep 22, 2014 10:56 pm

Thanks a lot Guys. I appreciate the info.

junebug · Post by **junebug** » Tue Sep 23, 2014 4:40 am

nice!!!!

my book has it listed as a : R2043 SLEEVEBOARD JACK
SPEAR & PEN,BONE,NO SHIELD,3 1/8", $150 MINT

Salernoslim · Post by **Salernoslim** » Tue Sep 23, 2014 6:11 am

Thanks jbug. I can see now why the old rems have such a following. It's a really solid knife.

All About Pocket Knives

Remington question

Remington question

Re: Remington question

Re: Remington question

Re: Remington question

Re: Remington question

Re: Remington question