Blades needed

[orvet]

I am looking for blades for these two knives.
I picked them up from a Marine buddy at the flea market.

The first is a New York Knife Co easy open jack. It really needs both blades but I can probably make the pen blade work if I can’t find one.
The obvious first preference is a NYK blade. The tang is .070” on both blades.

This is a nice OVB from Hibbard, Spencer & Bartlett. The problem is obvious. I have a spear blade that may fit this knife, but I would like to have the correct clip blade if I can find one. Blade tang is .098".

If you have a blade that might work, let me know.
I will buy or trade.

Thanks,
Dale

[knife-nut]

just saw this on ebay. http://www.ebay.com/itm/Vintage-Hammer- ... 5d35783d14

[orvet]

Thanks!

Bob (just bob) may have me fixed up with both knives.
I will let everyone know if they work out.

Thanks again!


That NYK is nice by itself. I think I will chase it a little ways!