Help with Case Knife

just bob · Post by **just bob** » Thu May 05, 2011 12:59 pm

This is a 316-5 / SSP Case knife. It has been laid too close to a fire and some of the leather rings on the handle have melted. I would like to attempt this repair myself but don't see how to get the butt end loose for repair. Would appreciate suggestions and advise.

tc3500 · Post by **tc3500** » Thu May 05, 2011 1:11 pm

I think if you look closely you will find that the end cap is pinned on. You will need
to drive this pin out to remove the pommel for your repair. Someone who knows
far more than I will come along. Also, have you searched this site? Very good info
here if ya look.

and welcome to aapk.com !!

TC

knifeaholic · Post by **knifeaholic** » Thu May 05, 2011 1:57 pm

My understanding is that the end cap on a Case hunter is actually formed of molten metal that is poured into a mold attached to the tang. So there would be no pin. I saw the setup to do this at the factory. You could try sending it to Case for repair.

Miller Bro's · Post by **Miller Bro's** » Thu May 05, 2011 9:32 pm

just bob wrote:This is a 316-5 / SSP Case knife. It has been laid too close to a fire and some of the leather rings on the handle have melted.

I have never seen leather melt. Probably because it does not melt, it will char or burn.

I don`t know exactly what happened to that handle but it looks like it was eaten away, maybe a hungry rat or some type of acid

The easiest way to repair that knife is to cut off the leather rings and leave the pommel in place. Then fit either wood, plastic, or bone handles in between the guard and pommel. Pin the two halves together and be done with it. JMO

Welcome aboard

jmh58 · Post by **jmh58** » Thu May 05, 2011 10:23 pm

Send to Case for repair.. John

just bob · Post by **just bob** » Thu May 05, 2011 11:20 pm

I did inquire from Case on this and they said $15 labor, $15 parts, and $7.50 S&H. That would put $37.50 in the repair and I'm not sure it's worth that. Thanks for the comments I will decide what to do from here.

orvet · Post by **orvet** » Fri May 06, 2011 3:28 am

just bob wrote:I did inquire from Case on this and they said $15 labor, $15 parts, and $7.50 S&H. That would put $37.50 in the repair and I'm not sure it's worth that. Thanks for the comments I will decide what to do from here.

If you could establish the age of the knife that might help you determine the value.
I know nothing about Case, but there are folks here who do know.

All About Pocket Knives

Help with Case Knife

Help with Case Knife

Re: Help with Case Knife

Re: Help with Case Knife

Re: Help with Case Knife

Re: Help with Case Knife

Re: Help with Case Knife

Re: Help with Case Knife