move over delrin

muskrat man · Post by **muskrat man** » Sat Dec 16, 2006 12:40 am

ironwood is here to stay.

justold52 · Post by **justold52** » Sat Dec 16, 2006 1:29 am

Real nice color in that wood too.

I have been looking for a place to buy spacers and pins for knifes no luck yet.
Where do you get your from?

JOE62 · Post by **JOE62** » Sat Dec 16, 2006 1:32 am

Looking good Muskrat Man!

muskrat man · Post by **muskrat man** » Sat Dec 16, 2006 2:13 am

Thanks guys

Jonet, I don't use spacers and I traded a guy for a bunch of NOS pins, so I can't help ya, sorry.

jonet143 · Post by **jonet143** » Sat Dec 16, 2006 2:29 am

i have knife parts you can have. i don't understand about the spacers and pins you refered to.

muskrat man · Post by **muskrat man** » Sat Dec 16, 2006 2:42 am

thanks Jonet, I guess I should have clarified a bit more.

spacers, I'm not sure if he was reffereing to brass liners or fiber spacers, I should have clarified that before I answered.

Pins, I am assuming he was referring to pivot and rocker pins, which I traded for alot of new old stock pins from the schrade factory. If he means the pins that the handles are attached with, then you can just rob those pins from the old scales, I have done it a few times.

Then again, if he is reffering to fixed blade knives, you can buy brass pin stock from most any knife makers supply.

Hope this clarrifies things a bit more

jonet143 · Post by **jonet143** » Sat Dec 16, 2006 2:44 am

i thought you were talking to me. it was justold ken you were talking to.

ken, try texas knifemaker's supply or any knife supply on the web.

arksknives · Post by **arksknives** » Sat Dec 16, 2006 3:07 am

Very nice wood on the knife!! Nice fit and finish! Very nice.

arksknives