Not sure where to post this, so if it needs to be moved....
Not sure where I got/found this, just don't remember. Not sure if it is any good for parts or what. Pretty rough.
This Old Knife
-
enuf
- Posts: 352
- Joined: Fri Dec 08, 2023 3:32 pm
- Location: T-Town, OK
-
FRJ
- Posts: 16316
- Joined: Fri May 14, 2010 1:43 pm
- Location: Ct.
Re: This Old Knife
It would be fun to know who made it.
Can you wire brush that mark side tang of the broken main blade? There might be a clue there.
How long is the closed length?
Can you wire brush that mark side tang of the broken main blade? There might be a clue there.
How long is the closed length?
Joe
-
enuf
- Posts: 352
- Joined: Fri Dec 08, 2023 3:32 pm
- Location: T-Town, OK
Re: This Old Knife
I see no marking on it. At one point it had a shield, but that is gone. Closed it is 3-iniches spot on.
Dan - ATA NSSA
-
OLDE CUTLER
- Gold Tier
- Posts: 4995
- Joined: Wed Oct 11, 2017 8:11 pm
- Location: South Dakota
Re: This Old Knife
You could make a knife opener, also called a knife pick out of it. See link below.
https://www.allaboutpocketknives.com/kn ... lit=opener
"Sometimes even the blind chicken finds corn"