Page 1 of 1
Knife construction question
Posted: Sun May 19, 2024 11:24 pm
by Ridgegrass
Anybody have an idea why Camillus put 4 scale pins in the mark side bone and 2 in the pile side? Only one I have like this. The others have 2 on both sides? Just noticed . Extra stress of the can opener ??? Thanks. O'.
Re: Knife construction question
Posted: Sun May 19, 2024 11:44 pm
by edge213
Ridgegrass wrote: ↑Sun May 19, 2024 11:24 pm
Anybody have an idea why Camillus put 4 scale pins in the mark side bone and 2 in the pile side? Only one I have like this. The others have 2 on both sides? Just noticed . Extra stress of the can opener ??? Thanks. O'.
There once was a shield there.
Re: Knife construction question
Posted: Sun May 19, 2024 11:53 pm
by Ripster
edge213 wrote: ↑Sun May 19, 2024 11:44 pm
Ridgegrass wrote: ↑Sun May 19, 2024 11:24 pm
Anybody have an idea why Camillus put 4 scale pins in the mark side bone and 2 in the pile side? Only one I have like this. The others have 2 on both sides? Just noticed . Extra stress of the can opener ??? Thanks. O'.
There once was a shield there.
Yep, should have been a shield there with 2 pins . Sometimes the shield was not recessed in the bone during production in this period .
Re: Knife construction question
Posted: Mon May 20, 2024 3:04 am
by Case V42
That utility knife with all steel liners and bolsters looks like it may have been a World War 2 U.S.A. contract. Many of those knives had a USA stamped shield, and happened to lose the shield after they were "liberated".
Re: Knife construction question
Posted: Mon May 20, 2024 4:24 am
by Ridgegrass
Duh! I'm really losing it! Thanks. My mind is springing some major leaks of late.

O'.