Page 1 of 1
Remington scout knife bail replacement
Posted: Mon Jun 25, 2012 10:47 pm
by RandyFew
Remington scout knife collector brothers, I need some guidance. I am wanting to replace a broken punch blade in an RS3333 scout knife, but it looks to me like there is a hollow pin on the bail end. What is the best way to rebuild that end of the knife so as to accommodate the original bail? I would rather leave the broken punch blade than take a chance on butchering up this fine piece.
Randy
Re: Remington scout knife bail replacement
Posted: Mon Jul 02, 2012 12:46 am
by remington collector
I've saw some welded blades that looked authentic. I'm not sure if you're against that type repair or not.
Re: Remington scout knife bail replacement
Posted: Mon Jul 02, 2012 3:35 am
by RandyFew
So I messed up. I apologized to the seller and bought the knife. It now lives at my house where it will stay until I am gone.
Re: Remington scout knife bail replacement
Posted: Mon Jul 02, 2012 11:13 am
by Miller Bro's
The knife can be easily repaired
