Bail needed for Camillus 4 line army knife

[rexstubbins]

I'm looking for a bail for this knife. The bolsters are nickle silver and all of the bails that I have or have been offered are steel.

Anyone have one?

[0078]

Find out if its the same bail as a tl29 if so pm me

[rexstubbins]

Find out if its the same bail as a tl29 if so pm me

I was going to say that the TL-29 was too long but when I found it in Blades Guide it looks like it has a long bail. I can't find an actual picture of one with the bail. All the ones that I have seen with nickle silver bolsters are the "U.S.A." marked ones and they have shorter bails with some detail work near the pin. The first picture is the one from Blades and the second is from the "U.S.A." marked knife. What do you think?

[0078]

There's a guy on here who goes by the name camillus ask him. Let me know what he says

[rexstubbins]

There's a guy on here who goes by the name camillus ask him. Let me know what he says

Carrmillus thought that it would be OK. If you wouldn't mind sending it I would appreciate it.

[0078]

The one I have is kinda of a square you can have if you want it just pm me your address

[rexstubbins]

I'm still looking for a bail that will work for this knife. It needs to be nickle silver and it needs to be somewhat longer. I found a picture of a knife that is similar. The shield is different but the bail on the knife is the proper one. The holes in the bail need to be 1/16" diameter.

If anyone has one that is nickle silver and is close in length that they would give up let me know.

Thanks.