Page 1 of 1
Interesting pins
Posted: Tue Feb 17, 2026 11:21 pm
by BestVintageKnives
Interesting, looks original to me.
Re: Interesting pins
Posted: Wed Feb 18, 2026 4:36 pm
by wiseguy
Hmmm. Nice knife !
Pins look odd to me , one looks “spun” but hey! You’d probably have a better idea of what it should look like

Re: Interesting pins
Posted: Wed Feb 18, 2026 5:01 pm
by BestVintageKnives
wiseguy wrote: ↑Wed Feb 18, 2026 4:36 pm
Hmmm. Nice knife !
Pins look odd to me , one looks “spun” but hey! You’d probably have a better idea of what it should look like
Good eye! Yes to are correct. The pins are original and spun. Punches with small cupped ends could have been used. I’ve seen people say these pins are wrong but they must have little experience to know the difference.
Re: Interesting pins
Posted: Thu Feb 19, 2026 4:47 pm
by eddymunster
I have recently seen a few German shell pullers with what appear to be "spun" pins for sale.
Not original I assume?
Re: Interesting pins
Posted: Wed Jun 17, 2026 10:11 pm
by Bill DeShivs
I need to correct erroneous information in this post.
While the pins on this knife MIGHT be original, the finish on them is not. The scale pins are obviously "spun."
Spinning pins to install was invented in America in the late 1940s, I believe by Remington-when they were making knives.
Cupped punches leave a completely different finish than is exhibited here.
The pivot pin has been peened with a small ball peen hammer, and badly done.
Re: Interesting pins
Posted: Wed Jun 17, 2026 11:52 pm
by Highspeedsteel
I think that’s how they made them