All About Pocket Knives

Well, I'm certainly no expert, but I've rehandled a couple of knives so I thought I'd try my luck with one of those "unhandled" Queen lockbacks from Cumberland. The knife came assembled so first I took the rocker pin and lanyard tube out of it so I could remove the lock. I didn't want to remove the pivot so I had to silver solder the 4 scale pins onto the liners. Then I just relieved the back of the scales to accept the solder. This wasn't too tough, just go easy with the solder. Backing up just a bit; I had rough cut the scales and fit them to the bolsters so I was able to drill through the liners to get my holes right. Then it was just sanding and fitting and sanding and fitting.....'til I got them to fit right. Peened on the scales , then fit the rocker pin and lanyard loop and PRESTO, new EDC for GJ! Actually, it took me a couple o' weeks in my spare time. Whaddya think, guys?

great job...beautiful...

looks goo to me! Though there are easier alternatives to pinning handles without disassembling the knife. Good job!

looks real nice to me.

muskrat man wrote: Though there are easier alternatives to pinning handles without disassembling the knife.

i sure would like to have that method described to me.... , please? is there a thread on that topic?

thanks, donald

GUNSTOCK JACK.. - great job mate! I just have to get myself into bone and stag....still enjoying the smell of wood dust for now though.

I've repaired scale pins by making a dome on one end, then just inserting it through the interior of the knife through the scale and peening the outside end of the pin....I used my steady to support the inside of the pin.

Kaleb - what's your method?

j
oops sorry Gringo...

Diligence wrote:Gringo - great job mate!

sorry..i was just commenting on the knife..i did not do this job....top of thread...
how embarassing..i wish i could do that good a revamp...

donald

Yes,please MM! Describe how it's done without disassembling knife. GJ

well fellas the main ingredient is a steady, but it can be done without one as well. When I'm well enough to get out to the shop I'll try and do a mini tutorial

Blast from the past, folks.
FYI, this is a 14 year old thread

I wonder if Gunstock Jack is still among us.

Nice job on it!!!

Very nice job!

I have got to get me some of that mastodon and give it a try.
I like the colors and shine you can get.

Is that stuff hard to work?

Again.... NICE job!

Quick Steel wrote: ↑Mon Mar 07, 2022 11:35 am I wonder if Gunstock Jack is still among us.

Last seen 2/14/22

Meridian_Mike wrote: ↑Mon Mar 07, 2022 12:38 pm Very nice job!

I have got to get me some of that mastodon and give it a try.
I like the colors and shine you can get.

Is that stuff hard to work?

Again.... NICE job!

Mammoth is similar to bone and stag in regards to toughness and ability to work it. It's just pricey...

Very nice end result! Old thread or not.

Great seeing the step by step, always wondered how the pins were soldered on there. Makes sense in a minute when you see it like this. Good one Gunstock Jack. Fabulous looking knife too by the way.