Page 1 of 1
Knife maker ID help please. Is this Kingston or ?
Posted: Wed Oct 16, 2024 7:56 pm
by Bigduck1
Hey there folks! Have another mystery knife I need a little help identifying. Picked up this 3 blade Cattle knife this past weekend at a rummage sale. The only Tang marking is USA on main Spear blade (which I had to round off a little because of breakage) Anyhow….it is very well made, solid everything. Super Strong pull/snap back springs. Two side Swedge grind on main. Single side Swedge grind on the Spey and a punch. NOT a hint of wobble , looseness anything! It is super solid. The punch is Crimped to fit to the side. Any thoughts or help with this always greatly appreciated!! Ready, Go! Thanks, Beck
Re: Knife maker ID help please. Is this Kingston or ?
Posted: Wed Oct 16, 2024 8:07 pm
by bestgear
Re: Knife maker ID help please. Is this Kingston or ?
Posted: Thu Oct 17, 2024 12:40 am
by Froe
Comparing to this old thread, it looks like one to me.
https://www.allaboutpocketknives.com/kn ... 1&start=50
Froe
Re: Knife maker ID help please. Is this Kingston or ?
Posted: Thu Oct 17, 2024 3:00 am
by New_Windsor_NY
Bigduck1 wrote: ↑Wed Oct 16, 2024 7:56 pm
Hey.....
I think it is a COLONIAL.
Re: Knife maker ID help please. Is this Kingston or ?
Posted: Thu Oct 17, 2024 5:30 pm
by Bigduck1
Kingston and Colonial were where my head was at as well. Do you have any thoughts on the USA with out the U.S.A. Dots? Does that lean it more one way or the other? Or does it send me a different direction? I get a bit confused by the whole Kingston mish mosh.
Beck
Re: Knife maker ID help please. Is this Kingston or ?
Posted: Thu Oct 17, 2024 8:35 pm
by knifeaholic
Kingston. It is identical in construction to Ulsters made in the 40's to 60's. Kingstons were basically rebranded Ulsters.
Re: Knife maker ID help please. Is this Kingston or ?
Posted: Wed Oct 23, 2024 3:21 pm
by Bigduck1
Thanks all for the help! Truly Appreciate it! Beck
