Page 1 of 1
Maker of this knife?
Posted: Fri Apr 19, 2024 5:24 pm
by treefarmer
Searched high and low and can't figure out who made this S&W knife. I posted it the other day in "knife finds of the day" and got no response as to the maker.
Trying again, who made this one?

- S&W celebrating 145 years in 1997?

- Stewart A. Taylor and Sons

- Smith & Wesson over USA
Two knives like it were listed on AAPK stores, one has sold, the was still available a few days ago. Neither mentioned the maker, somebody had to make it for Taylor.

Most listed S&Ws seem to be foreign mfg. and not of the quality.
Thanks for any help in identifying this knife.
Treefarmer
Re: Maker of this knife?
Posted: Fri Apr 19, 2024 6:09 pm
by just bob
Re: Maker of this knife?
Posted: Sat Apr 20, 2024 3:14 am
by treefarmer
Thank you for that link, just bob.

Very interesting indeed! Problem is that report is based on 1990 facts, the knife in question is celebrating a 1997 happening.
From the article jut bob referred me to, I gathered several mergers, buyouts, etc., finally became Alcas Cutlery Corporation. Seems Cutco knives are part of this.
Still digging, see if we can find anymore info on the S&W 145th Anniversary knife stamped with the Taylor name.
Treefarmer
Re: Maker of this knife?
Posted: Sun Apr 21, 2024 8:30 pm
by Modern Slip Joints
I am also curious who Taylor had make that series of knives. As you've learned most of the interest in S&W knives focuses on the knives S&W made themselves in the 1970s. While there is a little interest in the knives S&W had others make in the 1980s, there is minimal interest in newer S&W branded knives. However, some time in the last 10 or 15 years I read discusions about your series of knives on smith-wessonforum dot com in their sub forum covering S&W branded knives, accesories and collectibles. The members who knew the most are still active so posting a picture of your saddlehorn there might be your best bet.
I found only one clue. Your saddlehorn has a very distinctive shape. Among pictures of a series of S&W branded Taylor knives that included one shaped like yours but with different handle covers the tang of a trapper's secondary blade was exposed enough to read DE IN over APAN. Made in Japan?
Good luck.