Page 1 of 1
Tubing Size for Lanyard Hole - Schrade 6ot
Posted: Fri Feb 18, 2022 3:47 pm
by Jeffinn
I’ve got a couple of Schrade 6ot’s that’ll end up on the workbench soon. Does anyone know what size tubing is used in the lanyard hole?
Thanks.
Jeff
Re: Tubing Size for Lanyard Hole - Schrade 6ot
Posted: Sat Feb 19, 2022 1:37 am
by Wonderboy
This may be way off-base, but the lanyard hole in my Schrade 142OT is a snug fit for a 13/64 drill bit (.203125"). The tubing OD must be somewhere around 1/4" (.250). I don't have any Schrade folders for comparison, but just eyeballing the photos they look to be about the same. Hope this helps.
Re: Tubing Size for Lanyard Hole - Schrade 6ot
Posted: Sat Feb 19, 2022 3:04 am
by Jeffinn
Thanks wonderboy! I’ll see if 1/4” is a close fit.
Jeff