Page 1 of 1
Where did I get these-a little help pls.
Posted: Fri Apr 30, 2021 11:53 pm
by CharlieR
In rummaging through my older knife parts, I found these wonderful pre-cut folder pieces-liner, spring, blade. They are pre-drilled and shaped and ready to be ground and put together. There is a note that states AT-34, but that is all the info I have on them. I remember ordering these parts from some site but now have no idea where they came from. Anybody else remember these parts or where the came from? Help please if so.
Re: Where did I get these-a little help pls.
Posted: Sat May 01, 2021 12:14 am
by New_Windsor_NY
CharlieR wrote: ↑Fri Apr 30, 2021 11:53 pm
In.....
You might want to post your question here also.
viewforum.php?f=54
Re: Where did I get these-a little help pls.
Posted: Sat May 01, 2021 3:33 pm
by ea42
No idea where they're from but without a pin hole in the butt end of the spring and liner that knife's not going to work.
Eric
Re: Where did I get these-a little help pls.
Posted: Sat May 01, 2021 4:06 pm
by CharlieR
Hard to see but there are pin holes in place on the spring and liner.