Old Timer restoral
Posted: Tue Jan 21, 2020 12:24 am
Nothing special about this project; it was just a straightforward blade replacement in an Old Timer peanut. I had purchased a handful of blades from Discountcutlery.net, and dug through until I found two blades that fit (I don't think that they were exactly the same blades, but they fit and looked good. That is all that I was aiming for here).
I purposefully found a very beat-up knife to restore, because I am giving it to a friend who just retired from our company a couple of weeks ago. He had mentioned once that he liked "Old Timer" brand knives.
I am sending him the Before and After pictures, along with a reminder that God is not finished with him yet!
Jeremiah 18:1-4. The word that came to Jeremiah from the Lord: “Arise, and go down to the potter's house, and there I will let you hear my words.” So I went down to the potter's house, and there he was working at his wheel. And the vessel he was making of clay was spoiled in the potter's hand, and he reworked it into another vessel, as it seemed good to the potter to do.
Jeremiah 18:1-4. The word that came to Jeremiah from the Lord: “Arise, and go down to the potter's house, and there I will let you hear my words.” So I went down to the potter's house, and there he was working at his wheel. And the vessel he was making of clay was spoiled in the potter's hand, and he reworked it into another vessel, as it seemed good to the potter to do.