Page 1 of 1
Camillus #15 rescue
Posted: Mon Aug 26, 2019 11:46 am
by Meridian_Mike
Hey Camillus folks!
Y'all wanted to see what my Camillus #15 would look like with new clothes on....... so here she is.....
Just before I started taking it apart.......
When I started cleaning up the parts, I decided to leave the patina on the blades......
Why?..... Well, I don't know...... just seemed like the thing to do at the time.
With her new Culpepper smooth red bone scales.....
Thanks for everyone's help during the "show me one" phase.....
Mike

Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 12:01 pm
by orvet
That is a vast improvement Mike! It looks good!
Did you have to replace the liners?
Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 12:09 pm
by Meridian_Mike
Hey Dale....
I actually cleaned up the liners. They are brass and just had a load of gunk stuck to 'em. That was some nasty stuff..... oily, dirty cell residue is bad, but I did get it off.
Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 2:48 pm
by carrmillus
Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 2:57 pm
by New_Windsor_NY
VERY nice rehab job Mike.

Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 3:09 pm
by Meridian_Mike
Thanks y'all...
It might not be a raving beauty but I will have a #15 in my Camillus collection.
(I recon....)
And... it's in my pocket today.

Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 3:38 pm
by orvet
Meridian_Mike wrote:Hey Dale....
I actually cleaned up the liners. They are brass and just had a load of gunk stuck to 'em. That was some nasty stuff..... oily, dirty cell residue is bad, but I did get it off.
Wow you were really fortunate that the liners weren't cracked at the rocker pen. I have seen that happen a lot of times on the old celluloid Camillus knives. The Streamlines are famous for that!
I have taken Streamlines apart that seem to work well and had ok snap, only to find that there were cracks at both liners, and as soon as I took the handles apart you could almost watch the liners twst and crack further from the stress put on the rocker pins by the springs.
The surprising thing was that the knife from the outside didn't appear to be too involved in the outgassing process. Not nearly as bad as yours looked. It's really difficult to tell what damage has been done to a knife without taking it apart.
You made a great rescue of that #15!
Outstanding save and a great looking EDC!

Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 3:45 pm
by Meridian_Mike
Thanks again Dale.....
You know what.... I noticed all 4 of the bolsters had cracks. SO...... recon that came from the cell gassing. Well, dog gone it.....celluloid
IS a
REAL killer.

Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 6:26 pm
by rea1eye
Nice job Mike!
Bob
Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 6:33 pm
by Meridian_Mike
rea1eye wrote:Nice job Mike!
Bob
Thanks Bob!
After I found out most of the other #15s went to that great cuttler's bench in the sky, I just had to try to give this one a new lease on life. It sho' does tote good!

Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 8:39 pm
by Vit_213
Meridian_Mike wrote:....celluloid IS a REAL killer.
Yes! And I do not understand why many manufacturers (including Camillus

) used celluloid even in the 90s - 2000s, although they certainly knew about its properties.

Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 8:45 pm
by carrmillus
Vit_213 wrote:Meridian_Mike wrote:....celluloid IS a REAL killer.
Yes! And I do not understand why many manufacturers (including Camillus

) used celluloid even in the 90s - 2000s, although they certainly knew about its properties.

......it was CHEEP!!!!!..................

........................
Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 8:47 pm
by Meridian_Mike
carrmillus wrote:
......it was CHEEP!!!!!..................

........................
Like a little chicken..... cheep.... cheep... cheep......

Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 8:55 pm
by carrmillus
......by the way, mike, I watched "the outlaw josey wales" last night(took a break from john wayne)!!!!..........

....................
Re: Camillus #15 rescue
Posted: Mon Aug 26, 2019 9:05 pm
by Meridian_Mike
carrmillus wrote:......by the way, mike, I watched "the outlaw josey wales" last night(took a break from john wayne)!!!!..........

....................
Man... you just can't beat John Wayne or Clint Eastwood.
John is gone and I hate to say it but Clint shore looks OLD.
As long as we have the movies......
"You friend looks like he could use some help. This is what he needs.... ONLY $1 a bottle.."
"That stuff is good for almost everything, huh?"
"Almost anything...."
SPIT.....
"How is it with stains?"
LOL......

Re: Camillus #15 rescue
Posted: Sat Jan 08, 2022 2:43 am
by Ripster
Meridian_Mike wrote: ↑Mon Aug 26, 2019 3:09 pm
Thanks y'all...
It might not be a raving beauty but I will have a #15 in my Camillus collection.
(I recon....)
And... it's in my pocket today.
Mike do you still have this old knife ? They’re rather hard to find . You sure saved a great piece from being destroyed .

Re: Camillus #15 rescue
Posted: Sun Jan 09, 2022 1:24 am
by #goldpan
Great job. The handles complement the knife. You really brought that one back to life! What a great EDC that would make.

Re: Camillus #15 rescue
Posted: Mon Jan 10, 2022 3:28 pm
by Meridian_Mike
Thanks y'all...
Yep, still have it. It is sitting with my other Camillus knives all safe and sound....LOL.
