All About Pocket Knives

Made this from chain saw Spinner , Still have 3 Dies to Finish , ( .032-.048 ), But had a shop refab the handle today ! Looking Good K.C. Works Good Havent made something Yet thou , Pretty excited I did this thou ,

That is really cool off!
Have you used it yet and how well does it work?

orvet wrote:That is really cool off!
Have you used it yet and how well does it work?

Thanks dale ~~ Will Spin a ns Pin Down in about 5 Cranks I Have Yet to Jacket the Matching Pin sizes .I do This With 5/16 Hex Stock board to 1/4 in . Silver solderd , My one proto type pin is a compression fit thou , will post soon , Kodak crapped out ..lol ___ K.C. The Hand feeling you get while spinning is just awesome IMO Crank and tighten that simple ..I Sun some Pins that were Just peened , But I Havent gone thru the Pin stocks yet i.e Brass , Ns, Or stainless for that matter, Pushes the Nichel silver Around pretty easy thou , Like I said thou The matching pins are crucial so you don't mess the other side up while doing it , I have a Flat stop adjustment so I am going to spin on Handle pins first , Just to get the learning curve down first , __ Joe

Interesting! It's one of those ... "why hasn't someone else thought of this before" type moments
My Mate owns a Mower and Chainsaw shop ... seen these gadgets working plenty of times ... just never made the connection/cross-over to knives.


Derek

Thanks for the" Feather in my Cap "Derek I look at High tech machinery all Day , So I thought I would take a well deserved Break from it ,, __ K.C>