Page 1 of 1

1979 52 congress info needed

Posted: Mon Jun 04, 2018 6:08 am
by junom
Hi, I have a congress I need any information I can get, it's a r63052 ssp, it has long pulls on all three blades, I don't think it's from a set, like the ones that had red engraving on the blades. Thanks George God bless

Re: 1979 52 congress info needed

Posted: Mon Jun 04, 2018 10:22 am
by gsmith7158
George, you have to post pictures on a question like that. What brand is it?

Re: 1979 52 congress info needed

Posted: Mon Jun 04, 2018 11:45 am
by knifeaholic
junom wrote:Hi, I have a congress I need any information I can get, it's a r63052 ssp, it has long pulls on all three blades, I don't think it's from a set, like the ones that had red engraving on the blades. Thanks George God bless
Sounds like a 1980's knife, not 70's.

Re: 1979 52 congress info needed

Posted: Tue Jun 05, 2018 6:41 am
by junom
Hi it's a Case xx, the tang stamp is case xx with a lightning bolt s the lightning bolts and one dot to the left of them, U.S.A on the bottom. It has the raised letter case bold shield, I will see if I can get some pictures up soon, it's a nice looking knife, long pulls on all three blades I forgot where I got it from, it was in a roll I just got to it in about ten years, they get heavy after lifting out a few out of the safe, I think they get to about ten lb's when full, old age isn't fun, and hard work will hurt you. Thanks George God bless

Re: 1979 52 congress info needed

Posted: Tue Jun 05, 2018 6:47 am
by junom
Hi, I just checked a book it must be a 88 or 1989. Thanks George God bless