Page 1 of 1
Case Tested 3 Blade
Posted: Sat Dec 30, 2017 11:51 pm
by A&E
Just found this old knife in a new collection I just purchased. Anyone know the model #? It's 3 5/8" long. Nice tight snap. Fun going through this old collection. I'll be posting more pictures soon. Any thoughts on this knife appreciated. I'm planning on selling these knives so just getting as much information about them as I can.
Actually my plan is to sell most of them and possibly keep the best ones to add to my collection!
I have a large Case Copperlock collection which I shared on here years ago . . .
Re: Case Tested 3 Blade
Posted: Sun Dec 31, 2017 12:19 am
by gsmith7158
3 5/8 inches closed would put it in between an 18 pattern and a 47 pattern. Those are the only serpentine stockman knives with rounded bolsters that I know of. Looks like a 3318.
Re: Case Tested 3 Blade
Posted: Sun Dec 31, 2017 1:26 am
by jerryd6818
Eric, it has been a while. Good to see your smiling face. Welcome back.
There have been a few changes since you posted last. A few things are done differently these days. Check out the new Tips & Tricks Forum if you run into any stumbling blocks ---►
viewforum.php?f=98
Re: Case Tested 3 Blade
Posted: Tue Jan 01, 2019 11:17 pm
by A&E
I think this is a 3347 as it measures 3 7/8" . . . can anyone verify? I found this one on ebay but it doesn't have a punch blade like mine has.
https://www.ebay.ca/itm/RARE-VINTAGE-CA ... :rk:1:pf:0
Re: Case Tested 3 Blade
Posted: Wed Jan 02, 2019 5:13 pm
by Mumbleypeg
It's a 3347 PU. "P" for spey, "U" for punch.
Ken
Re: Case Tested 3 Blade
Posted: Thu Jan 03, 2019 4:17 am
by A&E
Thanks Ken! Much appreciated.