Page 1 of 1
Ima wearing a propellar beeenie (Boeing)
Posted: Thu May 19, 2016 4:24 pm
by MrBlister
needin a sheild... will gladly pay
HET and thanks
Re: Ima wearing a propellar beeenie (Boeing)
Posted: Sat May 21, 2016 6:18 am
by Bill DeShivs
Put a piece of scotch tape over the handle and trace out the hole.
Remove tape and apply it to your shield material. 5 minutes with a jewelers saw, and you have your shield.
Edit: I see that you need a FACTORY shield. Sorry.
Re: Ima wearing a propellar beeenie (Boeing)
Posted: Sat May 21, 2016 12:29 pm
by gsmith7158
MrB I believe this is the sheild that goes with that knife. Sorry I don't have one though.
Re: Ima wearing a propellar beeenie (Boeing)
Posted: Sat May 21, 2016 1:57 pm
by Mossdancer
Mr Blister:
Just saw your conundrum. Were you to call the nice lady at Case and give her the model info I am betting
she would mail you one. It has been a couple three years but she did for me.
Good luck,
moss