All About Pocket Knives

I've been asked to put together the specs for a club knife, and need more information to know if CSC should be considered. I tried contacting them via the email link on the webpage, but no reply. Is CSC still outsourcing blades and components, or is everything made in-house these days?

Thanks,
Jim

Jim,

Contact Michael Siegel at Droppointhunter.com
Michael is also a member here and he is the guy that can get you the answers you need and work with you on anything Canal Street wise

Michael's member name here on AAPK is. D.P. Hunter

Tom

Jim, everything's done in house. There was a time in the first year or two when Queen supplied most of the parts until in-house production could get up and running, but they've been out of the picture for a good seven or so years.

Eric

Thanks Eric! I wasn't able to find any information on the webpage about where the knife components are made, or a statement that they were all made in-house. When the factory didn't respond, I was prepared to assume the worst.

Jim