Page 1 of 1

Building a custom slipjoint

Posted: Mon Aug 05, 2013 12:04 pm
by wildcat
This was posted on the ABS website. Its an old post yall mighta seen it. Its on building a slippie from scratch but there is some useful info in there for sure.

Tutorial written by Master Smith Steve Culver.
http://www.americanbladesmith.com/ipboa ... -tutorial/


http://www.americanbladesmith.com/uploa ... -Part1.pdf

http://www.americanbladesmith.com/uploa ... -Part2.pdf