All About Pocket Knives

I kinda thought this would be a cool idea. The shell handles on this Imperial electricians knife were pretty much done for, so I replaced them with a set of slabs made from circuit board. The phenolic should last for ages. I also shaved the linerlock. It makes for a nice, thin, easy to carry folder. Another thing I like about these electricians knives, is the strong halfstops.
WB

Clever idea, W.B. I like it.

Love it! You are very creative!

Thanks guys! My brother gave me an unused 11" x 16" circuit board and I just had to try it. It's tough stuff and makes a pretty unique handle material.

WB

Awesome! I love it!
How hard would it be to do it with copper pins?
Again, very cool.
Mark

whitebuffalo58 wrote:It's tough stuff
WB

Tough stuff indeed. Ever try to break a circuit board. Not only is it extremely difficult to do with just your hands but IT'S DANGEROUS (I have the scars to prove it.)

Ramrod wrote:Awesome! I love it!
How hard would it be to do it with copper pins?
Again, very cool.
Mark

Thanks Mark!
You could do it with copper pins, but I don't think it would hold up as well as brass or nickel silver, especially at the main pivot. There may be a copper alloy or a tempered copper pin stock, but I don't know of any.

WB

Unique idea. Looks cool!

AWESOME IDEA.........LOVE IT!

Pretty cool WB......Pretty Cool indeed

Thanks fellas! I don't get much time to tinker these days, but this was a fairly quick and easy mod.

WB

Nice use of materials. Reminds me of the Camillus cyber knife.

Thanks guys!
I hadn't seen one of those Camillus Cyber's, pretty cool! Is it real circuit board or just imprinted to look like it?

WB

I have been busy and am just catching up on some old posts.

That came out really nice, I like it!

To answer your question on the Camillus, yes, as I recall they were made with real circuit boards.
IMHO, the coloration of your knife is much nicer than the Camillus.
IIRC, they were pretty expensive and were some of the last remaining stock in some stores.
They were apparently not fast sellers.

Nice job Rob!

Thanks for the compliment and info, Dale! I've never had one of the Camillus knives in hand, but I do like the dark green color on the circuit board I have. However, it might have been a good idea to have taken royals advice. The fact is the circuit contacts on this board were originally silvered, but when I glued them to the liners, some of the glue squeezed out through the holes and I had to sand through to the copper getting it off. DUH! I do like the looks of the copper and green together, but without the silvering, the copper may turn green over time. Nothing to loose sleep over, but if I want to maintain the silver color, it will require a different approach then I took on this one.

WB