Page 1 of 1
Schrade tool needs knife blade
Posted: Tue Dec 04, 2012 3:18 am
by cattaraugus57
Hi Guys,Don't know if this is the correct place to post this
Had one of these years ago when they first came out and it was stolen out of my car
To find another one will usually cost $75.00-100...I cant do that,but found
this one for a lot less BUT,The knife blade(of course) is broken.
Is there anyone here that can re-blade this for me??
Re: Schrade tool needs knife blade
Posted: Tue Dec 04, 2012 4:10 am
by 1967redrider
Man, all of those tools and someone had to pry with the knife blade.
Re: Schrade tool needs knife blade
Posted: Tue Dec 04, 2012 4:33 am
by Joe Dirt
Hay Catt, do you have a caliper to measure the inside diameter of the rivet?
I might have one. Oh, and how long is the rivet?
Also, how long of a blade are we looking for and what style & stamp?
...... Joe
Re: Schrade tool needs knife blade
Posted: Tue Dec 04, 2012 4:57 pm
by orvet
I think I can supply you with a blade.
Do you see one that looks right for it?
Re: Schrade tool needs knife blade
Posted: Wed Dec 05, 2012 3:01 am
by cattaraugus57
Joe, I do have one but I need to get a battery
I can prob get the Rivet out but as far as finishing a new one,that would be a problem right now.
Looks like 1/8 ID though.
Wonder who could finish the Rivet?
Joe&Orvet,The blade is the 3rd one down in Orvet's picture. length is a guess at around 2"..?
thanks guys
Re: Schrade tool needs knife blade
Posted: Wed Dec 05, 2012 3:03 am
by cattaraugus57
hey Redrider..that's exactly what I thought when I found it!!
Re: Schrade tool needs knife blade
Posted: Thu Dec 06, 2012 7:02 am
by orvet
I am not sure I could to a stainless steel tube rivet like that.
I have a flaring tool that works on copper tubing, but I bet stainless is a bunch harder.
I don’t think my flaring tool will work on it.
If you PM your address to me I will stick the blade in the mail to you. (no charge before you ask.)
Re: Schrade tool needs knife blade
Posted: Thu Dec 06, 2012 7:33 pm
by Joe Dirt
The largest rivet I have measures:
stainless,
.1185 O.D.
.0895 I.D.
.780 long
Dale, what is the diameter of the hole in that blade?
What length rivet do you need, catt?
...... Joe
Re: Schrade tool needs knife blade
Posted: Thu Dec 06, 2012 7:40 pm
by orvet
Joe Dirt wrote:Dale, what is the diameter of the hole in that blade?
0.190"
I am putting it in the mail today.
Re: Schrade tool needs knife blade
Posted: Thu Dec 06, 2012 11:33 pm
by cattaraugus57
Joe,Dale,The Rivet looks to be 3/4 long....The ID is Larger than the 1/8 I had said before :roll
thanks guys: