Page 1 of 1

dating a case

Posted: Sat Mar 17, 2012 6:46 pm
by paulsvintage
Could someone help with dating this congress whittler .53088ss thank you in advance.........

Re: dating a case

Posted: Sat Mar 17, 2012 7:21 pm
by Jeffrey
ive tried looking I cant find anything. ::shrug::

Re: dating a case

Posted: Sat Mar 17, 2012 7:39 pm
by paulsvintage
[quote="Jeffrey"]ive tried looking I cant find anything. ::shrug::[/quoteJ
Jeffery thanks ! i came up blank too !

Re: dating a case

Posted: Sat Mar 17, 2012 7:53 pm
by deanmm56
Paul,

I believe that is a Case Circle series knife made in 1986 ..... I think they were sold as a set of 3 knives, don't know if they were sold individually as well ?

Hope this helps.

Re: dating a case

Posted: Sat Mar 17, 2012 8:50 pm
by paulsvintage
::tu:: Dean, that helps a lot ! i bought it a 1986 but was not sure. the other circle series i have have blade etch..thanks again, Paul

Re: dating a case

Posted: Sat Mar 17, 2012 10:10 pm
by big monk
I have this one from 1986,Paul___came out of a busted set (someone stole the four blade )__there was a 2,3, &4 blade stag congress ***

Re: dating a case

Posted: Sat Mar 17, 2012 11:19 pm
by paulsvintage
big monk wrote:I have this one from 1986,Paul___came out of a busted set (someone stole the four blade )__there was a 2,3, &4 blade stag congress ***
:) Monk thanks, they put some nice stag on them.......

Re: dating a case

Posted: Sun Mar 18, 2012 12:52 am
by Jeffrey
Paulsvintage check out this link it may be helpful:

http://www.worthpoint.com/worthopedia/c ... -132604777

Re: dating a case

Posted: Sun Mar 18, 2012 12:56 am
by Jeffrey

Re: dating a case

Posted: Sun Mar 18, 2012 12:39 pm
by paulsvintage
:) Jeffery, thanks.....you guys are great ! better than Goggle ::nod::

Re: dating a case

Posted: Sun Mar 18, 2012 4:23 pm
by basser5
Paul that's a sweet looking knife, i like the stag ::tu::

Tim

Re: dating a case

Posted: Mon Mar 19, 2012 1:27 am
by paulsvintage
basser5 wrote:Paul that's a sweet looking knife, i like the stag ::tu::

Tim
thanks, Tim