Page 1 of 1
Help please
Posted: Wed Oct 05, 2011 12:32 pm
by just bob
Does anyone know what type of knife this is? The original blade was so worn I can't read it. Thanks
Re: Help please
Posted: Wed Oct 05, 2011 12:34 pm
by jerryd6818
Lady's Leg.
Edit: (Unless you were talking about the maker, then I wouldn't have a clue.
)
http://greateasterncutlery.net/blog/wp- ... rs-new.png
Re: Help please
Posted: Wed Oct 05, 2011 2:36 pm
by ddixon
Looks like two different tang stamps on the two larger blades. One looks like "Berkshire" which is a Simmons Hdwe brand, and the other looks like Iroquois, which is a Utica brand (according to Goins). Can't read the smaller blade.

Re: Help please
Posted: Wed Oct 05, 2011 4:10 pm
by just bob
I should have explained this better - my fault. I know this is a Lady's Leg knife. The original blade at the bottom of the picture is the blade that came out of the knife. The 2 other blades in the picture are blades I found in my junk that might work in this, but I'd like to know who the maker of the knife is. Thanks so much!
Re: Help please
Posted: Wed Oct 05, 2011 10:46 pm
by rangerbluedog
Looks like a Myrtle Corbin - no wait, the stripes are going the wrong way!
http://1.bp.blogspot.com/-VrMRUUsaq5o/T ... 1600/2.jpg
Seriously, it looks a lot like the new Schrades. I haven't seen an old Schrade leg knife, but perhaps they are similar ...
http://ladieslegknives.com/#/miscellaneous/4535554336
Look at this site and you can probably rule out H. Boker, Remington, Case, Pearl Dancer, Winchester, Voss, & NCCO
Re: Help please
Posted: Wed Oct 05, 2011 11:27 pm
by rangerbluedog
pen placement and eyelets in the boot make Brantford Cutlery a possibility...
http://www.allaboutpocketknives.com/kni ... &mode=view
The one in the link above belongs to ole CC Bill!