All About Pocket Knives

Howdy knifers,
I have some Marble's fixed blades with the Landmark
series blade etches in color
Bear MGC with North American hunting club etch on em

Question is, what would be the best way to return these
blades back to all steel look without scratching them all up ???
Hopefully, without using a buffing wheel
Your suggestions would be very much appreciated
Will

How deep is the etch?

Here's a pic of one of the etches Dale
They seem to almost be painted on
I can feel it raised above knife surface
Thanks !!!

I supposed you could sand it off with 400 grit wet or dry sandpaper.

Now if you want a high polish finish on the blade by hand, you will have to sand it all the way up through 8000 grit polishing paper. Then a buffer would finish it off to a high polish.
But you are probably talking about 8 hours + of hand sanding!
A LOT of hand work.


Personally, I would use my buffer and a Scotch Brite wheel.
It is much faster and gives you a more uniform pattern to the steel.

Dale

removing etches is next to impossible without t some point scratching or buffing the blade.

Thanks guys for your advice
I reckon I will take 1 and see what I can do with it
Would like to keep that fieldcraft as a spare huntin knife
Will

If you are just going to use it for a backup user, I wouldn't worry about the etch myself.
But that is just me.

Dale

Thanks again fella's, I actually got to thinking,
the boy will turn 40 day after opening day of deer
season this year, and i am gonna give it to him buffed,
with THE BIG 40 wrote on it
We allready have a few more things in store for him at the camp
Will

if the lettering is araised above the surface like paint as you say you might try a good quality stripper to remove the etch? Can't hurt.

GREAT iDEA !!!
I will give er a try
And Kaleb, got that slingshot you made for
me several yrs ago hangin in my gun rack
with the rest of my weapons
Will