Page 1 of 1
Elderly Wards equal end jack
Posted: Tue Mar 02, 2010 5:56 pm
by Mossdancer
Anyone with ideas on who contracted this knife? The shield inletting looks rather Remington. The secondary was or is not a punch. The liners look to be nickel silver although they are not part of the bolsters, they are separate. The knife is a full 4 1/4 inches closed.
moss
Re: Elderly Wards equal end jack
Posted: Tue Mar 02, 2010 6:02 pm
by rangerbluedog
Levine's 2nd edition says Utica, but I couldn't say at all...
Re: Elderly Wards equal end jack
Posted: Fri Mar 05, 2010 4:47 am
by ratlesnake75
Hello Moss, Just in my opinion, from the discussions I have had in the past by a few collectors, there were some wards knives made by winchester, most common tall tale signs of these "special wards knives" were the small winchester shield and a "pattern #" on back of their master blades. thx Mark
Re: Elderly Wards equal end jack
Posted: Fri Mar 05, 2010 4:59 am
by Mossdancer
Thanks Mark:
I think your probably correct however there is no stamp on reverse. I think there may be a possibility that Remington contracted for them also.
moss