All About Pocket Knives

More times than not a pen blade will only be stamped like yours (Remington, or Remington UMC inside a circle). Then the main blade will have the era stamp on it. I will have to look this evening but I don't think I have any pen knives where the stamps match.

Edit...here is a close-up of the R1013 I posted on the previous page.

Here's a few of of my Remingtons.

3¾" R3335 Scout. 2¾" R6434 Lobster Pearl.

A few more.

R1853 Bone 3-3/8" Long Pull . R2605 3-3/8" Yellow Pyremite Straightline Jack.

You have some nice knives Dan. Thanks for sharing.

Here is the "Tenth Anniversary Bullet Knife" 1982-1992
R11223-A Acrylic 4½" with 3½" blades. 1990 5¼" with a 4-1/8" blade. Remington Turkey Shoot Rifle shield. 11-87 Auto 870 Pump. #020 on front shield.

R1178 1991 Bullet Imitation stag. R1306 1990 Bullet Lockback. Imitation Stag.

espn77 wrote:You have some nice knives Dan. Thanks for sharing.

Thanks espn77.
And thank you for the info on my R7713.

Picked up a nice easy opener today. 3 3/8" . Blades have nice tight snap with half stop.
Probably paid more than I should've, but it just hit all the right buttons with me.

Nice knife lan. It is definitely hitting the right buttons for me. Great knife with a great etch. You probably didn't pay to much.

espn77 wrote:Nice knife lan. It is definitely hitting the right buttons for me. Great knife with a great etch. You probably didn't pay to much.

Thank you, Keith. My intentions were to buy a nice knife that I would carry, but I'm not sure I can bring myself to carry this one. It may just sit on my desk to fiddle with awhile!

R4703.4 1/4" moose.

That's a good looking moose. I like them big patterns

Wayne was kind enough to let this doctor's knife leave his collection. Still has a faint etch and inscription in the mop. The other one has a pretty good etch.

You'll on a roll Keith!

R1173 and his brother.

I believe the tang reads R1063. But the pics I've seen of that model had a bare-head.
3 3/8" closed.
Did Remington make this model with bare-head and with two bolsters?

Stewart & Ritchie show the R1063 on page 81 as a capped jack 3 3/8" identical to yours with the exception of the shield, which is slightly different.

Great looking knife lan

msteele6 wrote:Stewart & Ritchie show the R1063 on page 81 as a capped jack 3 3/8" identical to yours with the exception of the shield, which is slightly different.

Thank you for the info. I am going to to have to get a copy of their book.

They put them out both ways Lan. Here is mine.

Here is the R1062.

Two excellent examples! Was there any rhyme or reason to the different shields used?

LanG wrote:Two excellent examples! Was there any rhyme or reason to the different shields used?

I have wondered that same thing. Haven't been able to find a definate system yet.

I have a handful of display cases and for whatever reason I can't get this one set to not mess with. All the others never get rearranged. This is the line-up as of now.

I think it looks great Keith!