Page 13 of 14

Re: Easy Openers

Posted: Sat Jan 25, 2014 7:30 am
by singin46
Thanks Scott! ::handshake:: That's a different KENT there, never seen one in bone before.

Re: Easy Openers

Posted: Sat Jan 25, 2014 4:00 pm
by mickeyevans
nice knives Perry, learning from guys like you , I will be able to 'invest' in my herd and turn it into a real collection
I have kicked my ebay addiction, but had a small slip and got a bull dog doctors knife, did not have one of those yet,will post in the new purchase thread, soon as I get a photo

Re: Easy Openers

Posted: Mon May 04, 2015 11:24 pm
by Miller Bro's
They don`t get much nicer than this.

Re: Easy Openers

Posted: Tue May 05, 2015 12:57 am
by thegreedygulo
Very nice MRB! ::tu::

Re: Easy Openers

Posted: Tue May 05, 2015 3:36 am
by Miller Bro's
Thanks Roger! ::handshake::

Re: Easy Openers

Posted: Tue May 05, 2015 7:29 am
by TripleF
Absolutely beautiful Dimitri!! ::tu:: ::tu::

Re: Easy Openers

Posted: Tue May 05, 2015 11:45 am
by jerryd6818
This is one Dale gifted to me several years ago. I believe it may have originally had a pen secondary blade and the bail is missing but look at that bone. I think it's just gorgeous.

Re: Easy Openers

Posted: Tue May 05, 2015 1:28 pm
by TripleF
It is. It is! Very knice Jerry! ::nod:: ::tu::

Re: Easy Openers

Posted: Tue May 05, 2015 6:57 pm
by Lawrence
Beautiful looking knives, and thanks for reminding us of how great this thread is MB.

This is hands down, my absolute favourite knife in my collection. cheers

Re: Easy Openers

Posted: Tue May 05, 2015 8:50 pm
by terryl308
::bad_day:: It's raining here in the flatlands, so I went out and found my one and only easy opener and took a pic or two. It's a old Remington, R1673CH, black jig bone with two blades. All steel construction, no chain or bail though. I got it in a box of knives I bought at a auction a few years ago. Not too bad a find, I like the old stuff. AS ALWAYS, TERRY ::tu::

Re: Easy Openers

Posted: Wed May 06, 2015 12:05 am
by djknife13
I had to dig out a few. Nothing mint, but all good old examples and a few duplicates with little differences. Top left, Ulster Knife Co., Schrade, H.Boker, Utica (arched stamp), Imperial, Imperial, Imperial, Bottom right; Cam.(4 line), Pal Blade Co., Robeson(straight Stamp), Robeson (arched stamp), Cam. 3 line, Hartford Cut. Co.

Re: Easy Openers

Posted: Wed May 06, 2015 12:20 am
by djknife13
Here's a couple EZopener woodies. A Lafayette Cut. Co., Germany and A Marshall Wells. Zenith

Re: Easy Openers

Posted: Wed May 06, 2015 6:56 am
by Miller Bro's
Thanks Scott & Lawrence ::handshake::
djknife13 wrote:Here's a couple EZopener woodies.
Nice group of old knives DJ ::tu:: :D

That Lafayette Cut. Co. has the same style blade stamp as my Germania ::nod::

Re: Easy Openers

Posted: Wed May 06, 2015 2:40 pm
by orvet
I recently bought this Pal Blade Co. easy open jack, also known as the U.S. Navy general utility knife. I have a number of these knives made by Camillus, Schrade Cut Co, Imperial & Pal Blade Co. Of all the knives I noticed that the Pal Blade Co knives tend to have the softest tangs. If not oiled the tangs will quickly wear down.

When I picked this knife up the first thing I noticed was how sharp and crisp the jigging on the bone is. This knife doesn’t appear to ever have been inside of a pocket, the jigging on the bone is not worn down at all. The second thing I noticed about this knife is the snap on both blades; both blades make audible stamps upon opening to half stop, opening fully and upon closing. It’s like holding a miniature bear trap in your hands! I’m sure glad that these don’t have a Kershaw sharp edge on them, or I would’ve lost a finger the first time I opened it. It’s almost like Great Eastern Cutlery made this knife. Because of the hard snap I will not keep this knife. It’s currently in my AAPK store.

I believe this knife still has the factory edge; it does not appear to have been used or sharpened. Normally when you find these knives they have been used and worn down, however this one appears to have the full blade. I have never seen a Pal was such a full blade before.

Re: Easy Openers

Posted: Thu May 07, 2015 9:53 pm
by Miller Bro's
Nice looking knife Dale!

Re: Easy Openers

Posted: Tue Feb 07, 2017 4:43 am
by thegreedygulo
H. Boker & Co's Improved Cutlery.

Re: Easy Openers

Posted: Sun Apr 30, 2017 2:57 pm
by ratlesnake75
Hey GUYS, Hope No-one mines my showing off this EASY OPEN Strawberry bone Robey
Kind Regards,
mark

Re: Easy Openers

Posted: Mon May 01, 2017 12:11 am
by FRJ
Beautiful Robeson, Mark.
Has that thing ever been sharpened?

Re: Easy Openers

Posted: Mon May 01, 2017 11:36 pm
by ratlesnake75
Hey FRJ, Thanks Buddy!!
No Sir its a mint knife and Needs to find the right home? Do you know anyone that might have interest in it
Kind Regards,
Mark

Re: Easy Openers

Posted: Fri May 05, 2017 5:01 am
by roofsc
one

Re: Easy Openers

Posted: Sat Oct 24, 2020 8:14 pm
by LongBlade
Old thread I figured I would wake up with this one - bought it many moons ago but noticed I never got any photos so sharing it now....

LF&C Easy Opener - 3 & 5/8" closed - Ebony handles which for LF&C is more the rarity - every old catalog of LF&C clearly showed 2X as many black compo handled or celluloid knives than any done in wood or MOP - in fact not sure I ever saw a LF&C with jigged bone nor stag... One thing I will say about this knife is it is one solid hefty knife with surprisingly (as least to me) definite weight to it for a jack this size ::nod:: ..

Mark Side DSCN6085.jpeg
Pile Side DSCN6088.jpeg
Blades Open DSCN6103.jpeg
Tang Stamp DSCN6140.jpeg

Re: Easy Openers

Posted: Sat Oct 24, 2020 8:55 pm
by Quick Steel
Wonderful looking E/Os in this thread.

ratlesnake75, PM being sent.

Re: Easy Openers

Posted: Sat Oct 24, 2020 11:58 pm
by doglegg
EO's are seductive indeed. Lovely old knife. ::nod:: ::tu::

Re: Easy Openers

Posted: Sun Oct 25, 2020 2:05 am
by Waukonda
Nice, old, hefty knife! ::tu::

Re: Easy Openers

Posted: Sun Oct 25, 2020 2:13 am
by peanut740
Lee ::tu:: I'm not sure I've seen a jigged bone or stag LF&C either.