Kissing crane piece needed
Kissing crane piece needed
Looking for the locking spring for this 4 inch lockback. The one on the end of the knife
- muskrat man
- Gold Tier
- Posts: 5667
- Joined: Fri Jun 30, 2006 4:04 am
- Location: Ohio
- Contact:
Re: Kissing crane piece needed
These are easily made and installed. I just did one a week or two back. I can supply a piece of spring steel the correct width, you'll just need to bend it and trim it to length. Or you can send me the knife and I'll fix it.
Custom knives, repair, restoration & embellishment
Certified Hubertus, Taylor, & Schrade repairman past and present
http://www.muskratmanknives.com
https://www.facebook.com/Muskratmanknives
Certified Hubertus, Taylor, & Schrade repairman past and present
http://www.muskratmanknives.com
https://www.facebook.com/Muskratmanknives
Re: Kissing crane piece needed
I'll get with ya muskratman
Re: Kissing crane piece needed
When you get this knife apart you will find that the tail pc. is actually carbon fiber or some kind of hard rubber. Those 2 pins work together to keep the tension bar in place. Over time the synthetic material develops slop and the tension bar comes out. I had a small pc. of n/s and used the old tail pc as template and got this back together. Doubtful you can reuse the original tail pc. But maybe Kaleb can work his magic.
“The world is changed by your example, not by your opinion.” (Paulo Coelho)
Men make plans and God laughs
Better to remain silent and be thought a fool than to speak and to remove all doubt.
Men make plans and God laughs
Better to remain silent and be thought a fool than to speak and to remove all doubt.