Shield Size?
Shield Size?
I recently found a 97OT USA Buzzsaw Trapper for $10, and it's the Ducks Unlimited Limited Edition 2003 version, with oval logo shield. Unfortunately, that knife is also missing that shield. I see a couple different ones on Ebay as Ellenville leftovers, but the prices vary widely. Some people want $10 for one shield, and some want $10 for a pack of ten, a bit more reasonable if I come across more knives like this later. The cheaper ones are listed as being 5/8 by 3/8. Will it fit this knife?
Re: Shield Size?
I hate to sound like a smartass, but the obvious answer is, measure the opening in the knife handle where the shield is supposed to go. There are 'Schrade'' marked oval shields available that will fit too if you want something different and are not dead set on having a DU knife. If there is no opening in the handle for a shield then you have an unfinished DU knife and putting a shield on it would not be worth the effort of doing it right, imo.
See this page for pictures and info about End of Days, unfinished DU knives.
http://www.allaboutpocketknives.com/kni ... start=1605
See this page for pictures and info about End of Days, unfinished DU knives.
http://www.allaboutpocketknives.com/kni ... start=1605
-
- Posts: 893
- Joined: Fri Nov 23, 2012 8:14 pm
Re: Shield Size?
Cody, I think this is the knife you are referring too. If so I'm pretty sure I have a shield in my shop. I will look in the morning. If I have one I can send it out to you. A little glue and your in buisness. By the way this is one of my favorite schrade knives. Very solid useful pattern. Only problem is its too nice to use. I found a nice DU sheath to go with it. Fits perfect like it was meant to go with it. Maybe it was.
Re: Shield Size?
JAMESC41001 wrote:Cody, I think this is the knife you are referring too. If so I'm pretty sure I have a shield in my shop. I will look in the morning. If I have one I can send it out to you. A little glue and your in buisness. By the way this is one of my favorite schrade knives. Very solid useful pattern. Only problem is its too nice to use. I found a nice DU sheath to go with it. Fits perfect like it was meant to go with it. Maybe it was. image.jpg
That's a nice one. I don't think I've noticed that one before. Nice blade etch. I favor the 96OT Greenwing version. I'd like to replace the shield with the one that says OLD TIMER. I'm afraid to try digging the shield out of the handle though.
-
- Posts: 893
- Joined: Fri Nov 23, 2012 8:14 pm
Re: Shield Size?
These are the shields I believe your looking for. They are 3/4"x 3/16". Yours if you need them. Let me know I'll send them out
Jay
Jay