Page 2 of 2

Re: Weak snap on a GEC?

Posted: Thu Apr 11, 2019 11:12 pm
by ken98k
kootenay joe wrote:The 97 is a good user for those with experience in both knife use and field dressing. If you have not used a folding knife much or if you are not 'at home' field dressing a downed game animal, then the softer spring might mean you knock it to half stop. It is unlikely to go past the half stop.
The importance of experience with field dressing cannot be over-stated in this situation. Field dressing involves quite a few cuts, many are inside the body cavity with limited visibility. If you don't have all the moves 'down', then you could easily bump the blade spine and knock it to half stop.
A stronger spring would be better for those with less experience.
I hope to use my Tidioute 97 this Fall and if i do i will post how it went.
kj
You are going to tell an Alaskan Big Game Guide how to dress out game? :roll:
The bible say not to argue with a fool so keep on flapping your gums :lol:

Re: Weak snap on a GEC?

Posted: Fri Apr 12, 2019 4:05 am
by kootenay joe
Quote: "You are going to tell an Alaskan Big Game Guide how to dress out game?"
No.
I was just stating the obvious. If you or anyone is afraid of their 97 closing to half stop when in use then find a slip joint with a stronger spring or better yet, with a locking mechanism.
I am confident that my 97 Tidioute is safe for me to use. This is not about you or the 97 you have.
kj

Re: Weak snap on a GEC?

Posted: Sat Apr 13, 2019 4:34 pm
by Onearmbladejunkie
I own 5 GEC#97 Allegheny knives. I already paid for the Oregon club knife. The knife show is today , so I will receive my knife very soon. The Oregon Club knife and the American Whittler #97 have the best looking Antique yellow bone. My snaps are fine so far. I have one arm and these #97s were made just for me. I spotted some "S" stamped reduced priced #97s at "The Knife Connection" I bought two #43 "S" knives last year and they work perfect for me. I recommend the American Whittler knife. If you can't find a Sambar Stag #97 , go with the American Whittler with the large hounds tooth. The GEC#97s are the best Hunter knives for one arm me. "NO SUCH THING AS A PERFECT KNIFE !"
American-label-97.jpg

Re: Weak snap on a GEC?

Posted: Wed Apr 17, 2019 5:23 am
by Ajd3530
I've been saying for over two months, of only they had produced some with liner locks, there would be no issue. The collectors could get the lockless, and the folks who actually wanted to use theirs could get locks.

Don't get me wrong, I appreciate the workmanship that went into this pattern. Gorgeous knife, silky smooth action. But the weak spring combined with just how much leverage that big long blade is able to produce, and it pretty much takes it out of the equation for the pattern's intended use, (a folding hunter.) Sent my antique amber, err "autumn gold" back. I'll be keeping the yellow Rose in the collection.

Re: Weak snap on a GEC?

Posted: Sat Apr 20, 2019 6:25 am
by kootenay joe
I picked up my Northfield 97 with ebony handles today. Very well made knife with decent spring tension. I would call it a 5.0 - 5.5 for pull strength. I consider the spring tension to be correct for this pattern. My Tidioute maroon Micarta 97 has similar spring tension, just slightly less than the Northfield one.
Based on posts here it seems that some 97's have a weaker spring than others. I doubt it is all just owner preference.
kj

Re: Weak snap on a GEC?

Posted: Fri Apr 26, 2019 5:20 pm
by Open Range-19
::tu::
Ajd3530 your comments hit the mark with me. Fit & finish as well as walk-n-talk are fine but pull is weak to piddly on this one I bought. I considered sending it back but read the reviews and figured that's just the way most are on this run. My two cents to add; on folders, heavier pull or liner lock get the nod when reaching up to cut the windpipe when field dressing. On collectors I much prefer a firm pull and loud snap.

Re: Weak snap on a GEC?

Posted: Fri May 03, 2019 1:36 am
by Drukai
Glad I stayed away from this run..if I buy a big single blade slipjoint I want a 7 or higher pull n snap. That’s a big blade it needs some authority on spring tension. I hate light pulls make em strong it adds peace of mind while I’m using my knives!

Re: Weak snap on a GEC?

Posted: Fri May 03, 2019 3:49 pm
by markpreston
Ive been handling GEC at shows a lot lately and have definitely noticed the pulls getting weaker from about 2016 on. Maybe its just the examples Ive handled, I don't know. The modern Case and GEC seem about the same now on the pull. Older GEC and older case where much snappier. I like a stout snap but the sweet spot is objective to the user. Only knife Ive ever sent back to a dealer was because of almost non existent walk and talk. If I had to pick one brand out of the box that had the most consistent pull would be Victorinox or Wenger.

Re: Weak snap on a GEC?

Posted: Fri May 03, 2019 6:16 pm
by Open Range-19
I'll 2nd markpreston about those Swiss knives. My Wenger as well as others I've handled and all Victorinox I've crossed paths with, no issues. In addition IMO most Queens-even the late ones (that often have other problems; grind(s), hafting or polishing issues) tend to be snappy. I soured on Case's lazy blades productions from the 90's-unless they were made by Queen (Case Classics).

Re: Weak snap on a GEC?

Posted: Fri May 17, 2019 3:10 am
by Tsar Bomba
Drukai wrote:Glad I stayed away from this run..if I buy a big single blade slipjoint I want a 7 or higher pull n snap. That’s a big blade it needs some authority on spring tension. I hate light pulls make em strong it adds peace of mind while I’m using my knives!
Now y'all know why I asked for a granddaddy Barlow in the thread about dream future patterns from GEC. :mrgreen:

Oh, and for my final input into this thread: The new #12s seem to have solved the GEC "snap problem." If you consider them to have "weak snap" then I consider your judgment of snap to be misguided at best and outright silly (if not dangerous) at worst.

Re: Weak snap on a GEC?

Posted: Sat May 18, 2019 1:52 am
by Onearmbladejunkie
I own 22 GEC knives and two on the way. I have 4 fingers and one thumb ! I don't need no "gator snap" !
fb8790075443.png
fb8790075443.png (44.17 KiB) Viewed 3345 times

Re: Weak snap on a GEC?

Posted: Fri Oct 16, 2020 1:40 am
by Onearmbladejunkie
I just bought a 2017 GEC#38 Special in Tractor green . The pull is about a 5 at most. I love it. This GEC #38 is the best child's knife. I need to buy another one for a gift.

Re: Weak snap on a GEC?

Posted: Fri Oct 16, 2020 4:40 am
by kootenay joe
I agree that a folding knife does not need stiff springs. They should be easy to open but with enough spring tension to solidly hold the blade in the open position. But if it is not 'just right', then it is better to be 'too stiff' than 'too weak'.
kj