Parts needed.
-
- Posts: 351
- Joined: Sun Aug 28, 2005 12:14 am
Parts needed.
Does anyone happen to have a blade spring for a Case Tested XX 6165 hunter? Also any parts for a New York Knife Co. Four bladed Utility/Scout/ Army Knife that you’d sell? Thanks in advance.
KNFCOLLECTOR
Re: Parts needed.
I'm pretty sure I would have a spring for a 65, but you need to be careful on this. The thickness of the springs vary widely they may run from .085 to .115 or so. You would have to check the thickness and get back with me. Is it SS ?
“The world is changed by your example, not by your opinion.” (Paulo Coelho)
Men make plans and God laughs
Better to remain silent and be thought a fool than to speak and to remove all doubt.
Men make plans and God laughs
Better to remain silent and be thought a fool than to speak and to remove all doubt.
-
- Posts: 351
- Joined: Sun Aug 28, 2005 12:14 am