Customized Spinning Tool
-
- Posts: 806
- Joined: Thu Mar 23, 2017 2:17 am
- Location: Ulster Co, N.Y.
- Contact:
Customized Spinning Tool
Made this from chain saw Spinner , Still have 3 Dies to Finish , ( .032-.048 ), But had a shop refab the handle today ! Looking Good K.C. Works Good Havent made something Yet thou , Pretty excited I did this thou ,
Re: Customized Spinning Tool
That is really cool off!
Have you used it yet and how well does it work?
Have you used it yet and how well does it work?
Dale
AAPK Administrator
Please visit my AAPK store: www.allaboutpocketknives.com/orvet
Job 13:15
"Buy more ammo!" - Johnnie Fain
“Evil is Powerless If The Good are Unafraid.” – Ronald Reagan
AAPK Administrator
Please visit my AAPK store: www.allaboutpocketknives.com/orvet
Job 13:15
"Buy more ammo!" - Johnnie Fain
“Evil is Powerless If The Good are Unafraid.” – Ronald Reagan
-
- Posts: 806
- Joined: Thu Mar 23, 2017 2:17 am
- Location: Ulster Co, N.Y.
- Contact:
Re: Customized Spinning Tool
Thanks dale ~~ Will Spin a ns Pin Down in about 5 Cranks I Have Yet to Jacket the Matching Pin sizes .I do This With 5/16 Hex Stock board to 1/4 in . Silver solderd , My one proto type pin is a compression fit thou , will post soon , Kodak crapped out ..lol ___ K.C. The Hand feeling you get while spinning is just awesome IMO Crank and tighten that simple ..I Sun some Pins that were Just peened , But I Havent gone thru the Pin stocks yet i.e Brass , Ns, Or stainless for that matter, Pushes the Nichel silver Around pretty easy thou , Like I said thou The matching pins are crucial so you don't mess the other side up while doing it , I have a Flat stop adjustment so I am going to spin on Handle pins first , Just to get the learning curve down first , __ Joeorvet wrote:That is really cool off!
Have you used it yet and how well does it work?
- Brumbydownunder
- Posts: 450
- Joined: Sun Dec 27, 2015 7:14 am
- Location: Central NSW Australia
Re: Customized Spinning Tool
Interesting! It's one of those ... "why hasn't someone else thought of this before" type moments
My Mate owns a Mower and Chainsaw shop ... seen these gadgets working plenty of times ... just never made the connection/cross-over to knives.
Derek
My Mate owns a Mower and Chainsaw shop ... seen these gadgets working plenty of times ... just never made the connection/cross-over to knives.
Derek
"Belong Where The Moment Finds You"
-
- Posts: 806
- Joined: Thu Mar 23, 2017 2:17 am
- Location: Ulster Co, N.Y.
- Contact:
Re: Customized Spinning Tool
Thanks for the" Feather in my Cap "Derek I look at High tech machinery all Day , So I thought I would take a well deserved Break from it ,, __ K.C>