Page 1 of 1
Re: My first Schrade stockman repair
Posted: Tue Mar 21, 2017 12:56 am
by ea42
You can bend the spring to gain some snap too, just make sure you bend it just forward of the center pin hole, and not too much, a little goes a long way. You may have to re-grind the back a bit because the geometry might be thrown off, but it saves you the trouble of welding and grinding the spring. Trace the outline of the spring on some paper so you can gauge how much you're bending it.
Eric
Re: My first Schrade stockman repair
Posted: Tue Mar 21, 2017 11:42 am
by gwelker62
Look.... I'm trying to justify buying another welding machine. So don't be offering up any ideas that would be an alternatives to such.
Re: My first Schrade stockman repair
Posted: Tue Mar 21, 2017 12:19 pm
by gsmith7158
gwelker62 wrote:Look.... I'm trying to justify buying another welding machine. So don't be offering up any ideas that would be an alternatives to such.
George I'm with you buddy. I think you need one of those 30k laser welders. Please report back!
Re: My first Schrade stockman repair
Posted: Wed Mar 22, 2017 12:22 am
by gwelker62
Oh wow Greg.... if'n I had one of them there laser welders... I'd be the coolest kid on the block!