Search found 6 matches
- Mon Dec 18, 2017 12:34 pm
- Forum: Knife Repair and Restoration
- Topic: Machinists Bench Block
- Replies: 2
- Views: 1048
Machinists Bench Block
I am planning on making a Bench block out of O1 steel 1/2 inch thick by 2 inches by 3 inches . How hard should I Temper the O1?. I want to try the Bench Block before I try a Cutlers Anvil .
- Sun Dec 03, 2017 12:27 pm
- Forum: Custom Knives
- Topic: Using A Spot Welder
- Replies: 5
- Views: 3025
Using A Spot Welder
Can you use a Harbor Freight 110 volt spot welder to weld a nickel silver bolster to a nickel silver liner scale or a nickel silver bolster to a cutlers brass liner scale. Or would it take a Harbor Freight .220 volt. Or can a spot welder only weld stainless
- Sun Nov 26, 2017 12:09 pm
- Forum: Custom Knives
- Topic: Tapering Holes
- Replies: 8
- Views: 2156
Re: Tapering Holes
I need it for 3/32 and 1/8 inch holes
- Sat Nov 25, 2017 10:30 pm
- Forum: Custom Knives
- Topic: Tapering Holes
- Replies: 8
- Views: 2156
Tapering Holes
How do yall taper the hole in the bolster for a front pin in a pocket knife.
- Thu Nov 23, 2017 6:11 pm
- Forum: Custom Knives
- Topic: Nail Nick
- Replies: 6
- Views: 2855
Nail Nick
How is the best way to put a nail nick in a slip joint knife blade
- Thu Nov 23, 2017 12:48 pm
- Forum: Knife Related Tutorials
- Topic: Basic Disassembly, Repair & Reassembly of a Jack Knife.
- Replies: 56
- Views: 132437
Re: Basic Disassembly, Repair & Reassembly of a Jack Knife.
Thank you so much for the pictures at first. Where can I buy a Spring Compressor( Camillus type knife vise) and is that Micarta or leather in the Spring Compressor.. What type single edge razor blades have yall found to be the best to cut pins. I took and clamped a 1/4 inch piece of steel on a steel...