All T bar K Custom Knives (tbark44) Products
Here is a Hollow ground bowie style fighter with stag an stacked washer handles aluminum pommel soft back hard edge rc 58 hand made leather tooled she..
Here is a Lg size Fighter made from a old Saw mill blade from Arkansas 3/16 thic when started out brass guard with stainless center layer rockwell 58 ..
This was an Employee Sneak out i think , it come to me Un Ground blade Not heat treated Stamped ATS-34 on rear , knife was put togather in factory but..
Hello this is a older Horster BO/BC ,the knife had broke spring,plastic handles an cheesy safety, i dovetaild a new hand made spring in it put some ve..
Here is a Hot off the Bench Leather Stacked handl with dyed green burl center piece liner material aluminum pommel 416 ss guard ,440-C 5/16 thick blad..
Here is one of my regular pattern knives called BullRyder because its tough built like a Tank by Tank , D-2 blade is wicked sharp 3 5/8 blade 7 3/4 oa..
Texas Slim-Line Trapper single lockback Dual-Action auto maded with 440-C .070 thou thick blade elk stag handles fires great locks up solid , wicked s..
Trail Guide F model with Stainless 440-Can Guard made with 2 pc matched stag with leather stacked washer union G-10 center blade 5 3/4 10.5 oal,Custom..
Here is a new one off , made entirely of scraps in my shop from D-2 slip joint folder (ordinary Pocket type knife ) mother of pearl handles with G-10 ..
This is my standard Trapper Dual-Action auto . it has been scaled down to uber thin .074 thou thickness spine/blade 410 SS liners / bolsters saphire s..
Here is the newest one off from T bar K , Drop point edc type knife larger than i usualy make elk Stag handles with all Stainless liners bolsters. but..
Here is my latest creation from scratch , D-2 blades/springs , Stainless liners/bolsters nickel shield sambar stag handles Rockwell tested to 59 hardn..
Here is a spin off pattern of my Meercat Mini D-A very thin profile B&W cow horn shield is the button measurements in the pics on the ruler , for size..
New from T bar K, place on bolster is a dot matrix of a dove head or the best i could do for one on both sides nickel an brass with D-2 blade meausres..
Here is the newest off the bench , Elk stag dual-action auto button fired made from D-2 .100 thou thick blade nickel an brass , wicked sharp 600 grit ..
Here is one of my original trapper designs, Dual-Action button fired , 440-C blade 3 1/4 in oal 7 3/8 open the wood i believe is an oak burl , i found..
Hello Folks , Here is something new at T bar K start with 1/4 in 0-1 hand ground to a .003 thou edge before sharpening , this Razor is Shave Ready . f..
Hello ,I was contacted about individual spinners while i have not offered them in the past here you go it is up to you to specify the size wanted in c..
Here is one of my pin spinner set's it contains doming tools for pin sizes from .060 thou, to .148 thou . 1 double end for .080 to .115/ on one end ...
Showing 1 to 22 of 22 (1 Pages)