~~ CASE XX Travel & Pocket Knife Storage Bag ~~

Fabric is Cordura with a rubberized backing. Red embroidered CASE XX logo.

Two nylon web carry straps. Nylon zippers with two pull tabs. Each tab has a hole for luggage lock if desired, but not included.

One outside pocket with Velcro closures on each side.

Inside has Six (6) padded slots on each side and a removable center that holds five (5) knives to each side, it is padded also. This makes a total of 22 individual slots. Each slot is 5 3/4 inches deep and 2 1/4 inches wide.

Ruler shown in picture/image is for scale only.

Excellent way to travel and carry your knives to shows, swap meets, etc.

Cost includes shipping and handling in a cardboard box to lower 48 States Only

  $30.00

Quantity:  

~ Wittenberg Trading Company Camouflage Shoulder Bag ~

New with tags

Made from high quality Cordura. Heavy duty brass zipper pulls and nylon zippers. Wide nylon web adjustable shoulder strap and quality stitching makes this ready for years of rugged use.

One small side pocket will Velcro closure

Detachable waterproof cell phone carrier/pocket with three ink pen or pencil holders

One large zippered outside compartment with two attached compartments, large one with Velcro closure, the other a compression compartment with adjustable buckle and strap.

It has a large padded zippered compression compartment with snaps on each end.

It is 15 inches X 3.5 inches 13 inches empty

Great field bag, range bag, man purse or general purpose bug out bag.

Cost includes shipping and handling in a cardboard box to lower 48 States Only.

  $35.00

Quantity:  

~ Old BRIDDELL Butcher’s LAMB SPLITTER Cleaver Type Knife ~

It use is as the title implies.

It is marked very clear on the blade face:

BRIDDELL

MADE IN U.S.A.

No.93--12"

It is 19 inches long overall, handle is approximately 6 1/4 inches. Cutting edge is just shy a 12 inches. It averages out 2 1/2 wide with a hole for hanging, the last 1/4 inch is a "rolled edge" as found and should be on meat cleavers. There is a couple of minor chips but do not distract or hamper its use. It has some pitting and overall a dark gray patina, edge is bright from sharpening.

Full tang construction with walnut handles and brass rivets. One has been replaced with a copper rivet and has a crack, it is still tight and not loose in any way. The blade has an average of 3/8 inches thick and weight is approximately 2 pounds.

Charles Briddell himself started out as a kid making pen knives in the late 1800's. His dad saw tallent and took him out of school to learn to be a blacksmith. He had a black-smith shop in Quindocquay section of Somerset County, later having moved to Marion Station, and finally to Crisfield, Maryland around 1914. He incorparated in 1925, his company stayed open through our last great depression continuing production and providing jobs. He passed in 1938 after leaving work to go home and rest. One of his three sons, Charles D. Briddell, Jr carried on. In 1944, Briddell received the coveted Army and Navy "E" flag award for excellence in war production, such as bazookas and knives for the Pacific War campaign. After the war, the company eventually became Carvel Hall.

Excellent camp or survival tool. Cool looking for a cleaver or rustic kitchen display in the chow hall. Makes a great conversation piece that is not seen very often these days.

The BUZZARD ROCK watermark is displayed to deter image theft and will NOT show on the actual item you are purchasing.

  $83.50

Quantity:  

~ Vintage Bone BEAVER FALLS CUT. CO. Pennsylvania Table or Butter Knife ~

I will not say this is rare, but I have seen more of their pocket knives. Does not appear to have been used.

9 ½ inches in length overall. Two bone slabs held by two steel pins for a handle. There is a space between them and the blade, but line up with the pewter bolsters, so that tells me they were made that way. They taper flush at the end, full tang. There is no cracks or chips, the bone does not even appear dried out.

There is some stains and light pitting, excellent shape considering its age. I will leave it up to you for cleaning, if desired. The images/photos really do not do it justice.

Good and clear fonts stamped on the blade face. Pewter design is inlayed

Beaver Falls was in business from 1866 through 1886.

The BUZZARD ROCK watermark is displayed to deter image theft and will NOT show on the actual item you are purchasing.

  $20.00

Quantity:  

‹(•¿•)› CASE Straight Razor RED IMP

Hot stamped RED IMP over TRADE MARK and logo, shown. Tang stamps shown also, just click to enlarge.

Some water marks and light spider webs, shows signs of being honed also, no chips or nicks to the blade edge. I do not feel anything deep when I run it through my fingers, so I believe the blade should clean up if that is your thing.

Nickel silver pins. Blood red celluloid, White insert at larger end. Six inches closed. Never cleaned or monkeyed with.

I have seen the Red Imp made by several different companies, I do not know the story behind that name or trademark. If you do, I would appreciate the insight. One of Sargents guides says that Case made these for import to South America. Images tell the rest of the tale.

Only the best worked with straight razors back in the day.

As always, email with questions.

The BUZZARD ROCK watermark is displayed to deter image theft and will NOT show on the actual item you are purchasing.

  $50.00

Quantity:  

~CASE XX MAKO SHARK WITH BOX, SHEATH AND PAPERS~

As found/received from local estate. It has been stored inside leather sheath and box. All I did was removed for photos and a drop of oil. Everything is what came with it from Day One. So what you see before you, is what you get. I do not see any pitting or damage to the wood or metal, I just did not take the time to polish it up.

Etched MAKO inside a shark. Razor sharp, I shaved a little area on back of my hand just to test her out. Never used or wore other than that

Tang stamped :

CASE XX

...SS... ----> ...(Three Dots)SS...(Three Dots again)= 6 Dots total

USA

All with the "Lighting S"

Other side has:

P158L SSP

Inlayed pakkawood handles. Brass integral liners and bolsters. Smooth open and close. Clicks into place and locks up tight.

Sheath is still stiff and has a tooled design with the Case XX logo also.

The BUZZARD ROCK watermark is displayed to deter image theft and will NOT show on the actual item you are purchasing.

  $55.00

Quantity:  

~QUEEN Winterbottom Bone Carving Knife ~

It has been used, but not abused. I believe and it looks to have the original edge.

Full tang construction, tang is stamped with the Crowned Q logo and STAINLESS underneath.

Etched "FINEST STAINLESS" with the Crowned Q logo also, shown.

Aluminum guard and pommel, brass pins. No cracks or chips in the bone slabs. Mirror finish/polish.

It is approximately 15 inches long overall, cutting edge is approximately 9 ½ inches.

The BUZZARD ROCK watermark is displayed to deter image theft and will NOT show on the actual item you are purchasing.

  $35.00

Quantity:  

~PENN Knife Co. Cattle Pattern~

Does not appear to be ever used or carried.

Brass pins and liners. Bolsters are solid steel.

Tang stamp on master only is USA. Master blade etched "Penn Knife Co., INC." in script, shown.

Back composite handles, no cracks or chips. Blades/tool have a few spider webs with staining and age spots, bright mirror finish. Large & wide blades, long pull on spey. Excellent snap open and closing all three.

Feels made well. I am guessing and going to say this looks to be made in the 50's, I have never seen another and cannot find any history on it.

It is 3 5/8 inches closed.

The BUZZARD ROCK watermark is displayed to deter image theft and will NOT show on the actual item you are purchasing.

  $40.00

Quantity:  

~Two Well Loved USA Bone Boker Pocket Knives~

Great snap open and closing all blades and tool both ways with both knives.

Tang snap on both:

BOKER

USA

They both have the TREE logo stamp on back of each master blade also

Both with inlayed nickel silver shields, groved bolsters and brass liners.

Utility pattern

Brown jigged bone handle/scales and brass pins. Tight hairline from pin to bolster on shield side, one tight hair line on other side from pin to bolster also. The blade has been honed, not machined ground...still a fine user or carving tool.

Cattle Pattern

Slanted grooved bolsters, pinched bolsters, brass liners. Black jigged bone handle/scales and nickel silver pins, no cracks or chips. Another fine user or carry knife.

The BUZZARD ROCK watermark is displayed to deter image theft and will NOT show on the actual item you are purchasing.

  $40.00

Quantity:  

~GERBER DURENDAL Boning Carving Knife~

Made as a bone knife, but would make an excellent filet or fishing knife.

Appears to have original edge.

No dents or dings to the handle.

There are some rubs/scratches to the blade, but nothing deep or anything like that

It is 11 15/16 inches in length with a cutting edge of approximately 6 1/2 inches

The BUZZARD ROCK watermark is displayed to deter image theft and will NOT show on the actual item you are purchasing.

  $14.95

Quantity:  

~ Old Time Near Mint Stag Handle Sharpening Steel ~

Nothing high tech about this.

Steels are used after honing for a fine razor edge, they take less steel away. Known in the meatcutting trade as a slick, steels like this are best for users who want to sharpen their knives with greater frequency, since they take less steel away from the edge.

This one could have came from an older Case XX carving set, if you are looking for one. The stag color and style/metal work of it appears the same as some pre 1940 carving sets I have looked over or seen on the web. I was told that by original owner also, but have no way to verify. This steel came with a small collection I purchased several years back. The collar did not match any of the other pieces, so it got put back alone. Maybe someone on the knife forum's will know.

Near mint, I rubbed a blade a couple of times and you can see the few rubs when it is in your hand. No rust.

Collar could be Sterling silver also, it has turned like silver would, but it is not stamped anywhere. Nickel silver does not turn blue/black as it ages, see photo's. The pommel is nickel silver.

No cracks or chips to a semi-round solid piece of stag. Feels good and solid in my hand and I wear an large leather work glove.

Handle is approximately four (4) inches long, overall the steel is 12 & 5/8 inches in lenght.

Stay Kewl around the camp fire or home on the range with this. Just the right size for a pocket, hunting knife or your cutlery display.

  $24.95

Quantity:  

  $4.99

Quantity:  

  $48.00

Quantity:  

  $38.00

Quantity:  

  $48.00

Quantity:  

  $30.00

Quantity:  

  $5.99

Quantity:  

  $20.00

Quantity:  

  $20.00

Quantity:  

Vintage Pair JOHN PRIMBLE BELKNAP Shears Scissors

They make that snipping sound when used, nice and tight. Edges look to have been sharpened at some point in time and are still sharp.

Light etch "John Primble" still visible on front/stamp side. Looks like ole English fonts. Stamp shown.

I do not see any active rust, but there is some spotting and tarnish. See images closely, they are part of the description.

Nice oddball addition to your cutlery collection.

They are 7 1/4 inches in lenght.

  $10.00

Quantity:  

page 1    2